Universal 12V Deer Feeder Motor — 1/4" Shaft

Boss Buck Universal 12V Deer Feeder Motor - 1/4

Keep your feeder running without buying a whole new control unit — the Universal 12V Deer Feeder Motor with 1/4" Shaft is a direct replacement motor built to restore power and reliability to your existing feeder setup.

This is a genuine 12 Volt PM DC motor delivering 1/35 horsepower, spinning at 2,942 RPM at 2 amps. It draws 4½ amps at startup and settles to a steady 3 amps while running, giving you the consistent torque needed to keep a spinner plate turning reliably feeding after feeding. The 1/4" x 1" shaft is a standard fit across a wide range of feeder brands and control units, and mounting studs spaced 2.36" apart make swapping out a worn or burned-out motor a straightforward job without needing to replace your entire timer or control unit.

Whether your feeder's original motor has finally given out after years of service, you're troubleshooting a feeder that's stopped spinning reliably, or you just want a dependable spare on hand before hunting season starts, this universal motor gives you a cost-effective way to get your feeder back in action without the expense of a full replacement kit.

Note: This is a replacement motor only. Timer, spinner plate, and mounting hardware for the timer bracket are sold separately unless otherwise specified.

Frequently Asked Questions

Q: What size shaft does this motor have?
A: It has a 1/4" x 1" shaft, a standard size that fits a wide range of deer feeder control units and spinner plates.

Q: What's the RPM and power output of this motor?
A: It's a 1/35 horsepower motor running at 2,942 RPM at 2 amps, drawing 4½ amps at startup and 3 amps while running.

Q: Will this motor fit my existing feeder?
A: This is a universal 12V motor with standard 1/4" shaft sizing and mounting studs spaced 2.36" apart, making it compatible with most common feeder control units. Check your existing motor's specs to confirm fit before ordering.

Q: Can I use this to replace a motor that's stopped working?
A: Yes. This motor is designed as a direct replacement for a worn-out or malfunctioning feeder motor, letting you fix your feeder without buying an entirely new control unit.

Q: Does this motor come with a timer or spinner plate?
A: No, this is the motor only. Timers, spinner plates, and other components are sold separately.

Q: Is this a good item to keep as a backup?
A: Yes. Many hunters keep a spare replacement motor on hand before hunting season to avoid feeder downtime if the original motor fails.