All Seasons 12V Gated Spinner Plate w/ Swing Doors — 1/4"

All seasons 12v Gated Spinner Plate (w Swing Doors) - 1/4in

Cut down on wasted feed and keep more corn where it belongs with the All Seasons 12V Gated Spinner Plate with Swing Doors — 1/4" Hub, a direct-fit replacement spinner plate built to reduce spillage every time your feeder cycles.

The swing gates on both ends of the plate open when the feeder motor runs and swing closed the moment it stops, helping keep more feed contained on the plate and less scattered on the ground between feedings. This gated design offers a real step up over a standard flat spinner plate, cutting down on the feed waste that draws unwanted attention from wind and ground-feeding pests. The 1/4" hub is sized to match the motor shaft used on ASF feeders and most other standard 12V control units, so fit is straightforward if you're ordering a replacement for an ASF unit specifically.

Built for durability, this spinner plate is designed to hold up to repeated outdoor use and regular feeding cycles without breaking down. Installation is simple: attach to your motor's shaft and you're ready to go, no complicated setup required.

Whether you're replacing a cracked or worn-out spinner plate, upgrading from a basic flat plate to reduce feed waste, or completing a DIY feeder build, this gated spinner plate is a simple, effective upgrade for your feeding setup.

Note: Confirm your motor shaft size before ordering. This plate is sized for a 1/4" shaft hub — a 1/8" hub version is also available separately if needed.

Frequently Asked Questions

Q: What does the "gated" design of this spinner plate do?
A: Swing gates on both ends of the plate open while the feeder runs and close when it stops, helping reduce feed loss and keep more corn on the plate instead of scattered on the ground.

Q: What shaft size does this spinner plate fit?
A: This version fits a 1/4" motor shaft hub. A 1/8" hub version is available separately for feeders with a smaller shaft.

Q: Will this fit my ASF feeder?
A: Yes. ASF feeders typically use a motor with a 1/4" shaft, so this is the correct spinner plate size for a direct replacement.

Q: Is this compatible with other feeder brands besides All Seasons?
A: The 1/4" gated spinner plate is a common size used across many standard 12V feeder control units, but you should confirm your specific motor's shaft size before ordering to ensure a proper fit.

Q: How do I install this spinner plate?
A: It attaches directly to your feeder motor's shaft, making installation straightforward without additional tools or hardware in most cases.

Q: Why would I upgrade from a standard flat spinner plate to a gated one?
A: A gated spinner plate helps reduce feed waste by closing off the plate between feeding cycles, which a standard flat plate doesn't do.